Septic owner guide
Putting the camper away for winter? Empty the holding tanks first
The last trip of the season ends, the camper gets backed in beside the shop, and whatever is still in the holding tanks stays there until spring. A Pocatello winter finds that leftover at the valves and on the tank floor, so the time to empty it is before the rig sits.
On the benches and the Tyhee acreages, plenty of campers and fifth-wheels come home twice in the fall. Once after the last summer trip, and again after the October and November hunting trips down toward Inkom, McCammon and Lava. The second homecoming is often the one where nobody stops to dump. The rig gets parked by the shop late on a Sunday with the gray tank holding a weekend of camp dishwater, and it stays that way until the snow is gone.
This guide is about the waste side, the black and gray tanks. Blowing out the fresh-water lines and bypassing the water heater is the other half of putting a rig away, and that is work for an RV shop.
Should a camper’s holding tanks be empty before it sits for the winter?
Yes, both of them, black and gray, as close to empty as a pump-out gets them. What stays in a stored tank runs down to the lowest points of the waste plumbing, where it can freeze, and what stays in the black tank sets up into a layer that is harder to move by spring. RV pumping in Pocatello empties both tanks at the rig, where it is parked.
Half full is the usual state for a rig that was used right up to the last weekend. It comes home with some of each, and the question is how much is left and where it sits when the cold arrives. A few inches spread across a tank floor makes for a different winter than a tank a third full with water standing in its valve body.
Gray water is the one people let slide, since it is only sinks and the shower. Sealed in a tank from November to April, it goes sour, and the camp-kitchen scraps that settled out of it are still on the floor in spring.
Is the last dump-station stop of the season enough?
For a rig that went through a dump station on the way home and had its black tank flushed there, often yes. The pump truck is worth it for the rig that came home with its tanks still in use and was parked without a stop, or one already leveled and blocked beside the shop that is not going back on the road until spring.
A road-ready rig has the cheaper option, and the RV holding tank pumping page says when a dump station is the better call. What a dump station cannot do is reach a rig after it has been set down for the season. Once the jacks are down and the batteries are out, hitching up to drive across town and back is more work than the dump seems worth, and that is usually when half-full tanks get left.
A dump stop also has a limit. Gravity drains what will run, and the solids clinging to the black tank’s floor and walls go into storage with the rig.
What does a Pocatello winter do to what is left in the tanks?
A stored camper has no heat on its tanks. The leftover liquid collects in the lowest and most exposed parts of the waste plumbing, which are the tank bottom, the valve bodies and the short pipe to the outlet, and it freezes and thaws there all winter. Solids left in a black tank dry onto the floor and the sensor probes.
Unlike a rig someone lives in, a camper parked by the shop with the power off sits at the temperature of the air around it, and on an open bench lot that air comes with wind. The outlet side of a rig parked along a fence line or the north wall of the shop gets no sun at all, and it stays frozen longest.
The valve bodies and the outlet pipe hang below the tanks, which is why water gathers there, and they hold the least of it. A small amount of water in a tight space freezes fast and has nowhere to go as it expands. A tank with a few inches across its floor has room for the ice. A slide valve with water sitting in its body has none, and neither does the termination fitting at the outlet.
A bench winter is not one long freeze, either. Sunny afternoons warm the dark side of a rig, the nights drop back down, and the water in a valve body can freeze and thaw many times between November and March. Each cycle works a little more on a seal or a thin plastic housing. Nobody sees the crack in January. It shows up in spring as a drip under the outlet the first time water goes into the tank.
The black tank has a slower problem. Over the months its liquid evaporates out through the vent, and what was suspended in it settles. By spring that layer is stuck to the tank floor and coats the sensor probes in the tank wall, and the first flush of the year runs over the top of it instead of carrying it out.
Does RV antifreeze go in the holding tanks, and is it hard on a septic tank?
The product for RV plumbing is the pink antifreeze sold for drinking-water lines, usually propylene glycol. Automotive antifreeze is ethylene glycol, which is poisonous and never goes in a rig. Whatever is poured down the sinks and toilet in fall to protect the traps ends up in the holding tanks and comes out with the first dump or pump-out in spring.
Whether that is hard on a house septic tank comes down to quantity. In our judgment, one camper’s winter dose is small next to what a household tank holds. Several rigs dumped into the same cleanout, or gallons poured in at once, is a heavier load, and a pump-out at the rig sends it to the truck instead.
What should the tanks and valves look like when the camper is put away?
Pumped empty and dated, valves set the way the rig’s manual says for storage, the outlet capped, and the outlet side left where a hose can get to it in spring. Each of those heads off a specific spring problem, and the panel gauges are the one reading not to trust.
- Both tanks pumped, with the date written where the next person to open the rig will see it. Spring then starts from a known empty instead of a guess.
- Valves in the position the rig’s manual gives for storage. Manufacturers do not all agree, and the manual for your valves beats any rule of thumb.
- A cap on the outlet. Over five months it keeps mice and blown dirt out of the pipe, and a wet ring under a capped outlet in spring tells you a valve is weeping.
- The outlet side facing open ground, not the shop wall or the fence, with the winter woodpile and the plowed snow kept off that side, so a spring pump-out can reach it without digging.
- Gauges read as a rough guide only. Residue on the sensor probes can keep an emptied tank reading partly full, so the dated note is the better record.
What shows up in spring if the tanks went into storage half full?
The first dump or pump-out of the year carries everything the rig held over: the antifreeze from the traps, the last trip’s gray water and whatever settled in the black tank. A valve that froze over the winter shows itself next, when it will not pull or when the outlet drips after the first water goes in.
A slide valve that will not move on a cold April morning gets the same treatment as any cold valve. Leave it for the afternoon instead of forcing it. A drip at the outlet with every valve shut points at a valve seal or a cracked valve body.
A black tank that went in half full and dried down over the winter will not drain clean on the first try. It needs water added before it will pump, the same as a tank that sat with its valve open. From the outside it looks like a dump that ended too soon, with the rinse water still running dark well after it should have come clear.